Final Project

Components:
2 resistors of 1K
1 pot of 100k
1 capacitor of 47nF
1 capacitor of 0.01 uF
1 Led
Sourse of 5 volts
1 Protoboard
Cables

First we conect the resistors, to the pines , 1k to pin 6, and this one conected to pin 7, remember that pin 2 and pin 6 are conected together, the capacitors are conected to pin 6 and pin 5, both capacitors are conected to ground, finally we conect the pot with the other resistor of 1k, and this pote goes to the sourse of 5 volts, pin 4 and pin 8 are conected too, the out we can see it with the led in pin 3,any doubt see the diagram of the circuit, finally we connect the source of 5 volts

As we see led goes on and off, that’s because of the frecuency, if we move the pot, we can increase the frecuency faster o slower. This circuit can be used in many others circuits to give a needed signal.